Are you searching for free chicken coop plans? A lot of chicken coop designs and chicken house plans can be found online, however which of them offer you what you ought to build quality chicken coops? Exactly where do you get the very best hen house plans or chicken house designs? Here is the free hen house plan to make your own chicken house, be sure to explore the earlier parts of plan.
You are nearing completion on your new chicken coop. It is time to sheath the roof. Start by cutting four (4) sheets of plywood as detailed below. Keep both sides.
You can really sheath how you wish, but for a little guide we have numbered the detail below to show where sheathing can go to reduce the amount of waste.
Now, all you need is a 1 x 4 (25 x 90mm) plank to put across the top, front of the overhang. Also, the roof should be strong enough to support most snow loads, but if you live in a high elevation area, add some braces to the overhang on the front. If you are intending on adding trim, do not attach anything to the front of the overhang.
Now, for all intensive purposes you are done with the chicken coop! Congratulations! We have included a list of trim pieces that will enhance the look and overall aesthetics of the chicken coop.
Some general notes:
- These drawings are intended as a guide only. While the drawings are complete and may be followed carefully, you should always check measurements to confirm. Saw blades vary in thickness with age, lumber thickness can vary by country or standard. Too many variables exist, not to mention the construction competency of the builder.
- While these plans are written with the most basic steps laid out, some builder competency is expected. Especially with the trim as the pieces need to be tailored very specifically to fit just right. You also need to know how to use your own tools and to know what types of tools are listed in these drawings.
- The chicken access, for all purposes is the rear door. We will be installing a smaller access in the rear of the chicken coop, but this is up to the builder and is not required.
- Ramps and chicken runs are simple structures but drawings are included in the following pages.
Don’t forget the brace in the front. Simply hold a 3-4′ (900-1200mm) plank against the side and mark your cuts.